Audi Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hi

I've been working on a problem with my 80 2.6 where the oil pressure warning comes on after 3.5 bar of pressure reads on the VDO.

I've done a number of things including replacing the 2 sensors that are located above the oil filter (this I've also changed along with the oil).

I've heard of VAG-COM, but am not sure exactly what it can do. My question is - is it possible that by getting a VAG-COM reset my issue may be resolved? I know there could be other reasons for the warning, but after replacing the sensors I found that my airbag light stays on for a couple of minutes after start up whereas it used to go out after a few seconds as part of the diagnostic that happens on start up, so I'm hoping that I can correct any buggy behaviour

Any information on VAG-COM would be appreciated.

Thanks
 
1 - 1 of 1 Posts
Top