Audi Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Is there a way to remove the break rotors on a 2007 Audi Q7 without removing the calipers? I removed the pads and the rotor lock-down bolt, but the rotor will not slide out of the caliper.

Thank you!
 

·
Registered
Joined
·
3 Posts
Is there a way to remove the break rotors on a 2007 Audi Q7 without removing the calipers? I removed the pads and the rotor lock-down bolt, but the rotor will not slide out of the caliper.

Thank you!
You will have to remove the caliper and pad carrier to replace the rotors. The bolts on the front carrier are 21mm and on the rear are either 14 or 17mm mulipoint drive. Note; The carrier bolts are very tight on the rear pad carriers just to let you know!!!.they may fight with you!! good luck!!!:)
 
1 - 2 of 2 Posts
Top