Audi Forums banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·

I'm Bob and I just acquired an '87 5000 Q that seemed not to be ran too slow. I put my timing light on the ign. mark on the flywheel and it did not move when I increased the RPM. Thus, I concluded that the engine has no timing advance. The hot /cold sender unit checked out OK and my mechanic replaced my CPU with one from another 2.3 NF 100..and it made no difference. My CPU was put in the Auti 100 and that engine ran fine? Any body have any ideas what esle it could be? It's a brain teaser!

Thanks, Bob
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.