Audi Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hi im new to the forum and a new owner of a 1996 audi a4 2.8. i want to put a cold air intake in the car and am planning to make a heat shield and what not but what do i do with the mass air flow sensor and power output sate that are on the current intake?
 

·
Registered
Joined
·
75 Posts
Yes, I had the flange laser cut in stainless steel, then welded a piece of 40mm stainless tubing onto it. The aluminium tubing just before the inlet manifold should be longer, but there was'nt enough space.
 
1 - 4 of 4 Posts
Top