Audi Forums banner

Big problems with airbag light and occupancy Sensor

1219 Views 0 Replies 1 Participant Last post by  marcuskearton
No fault codes but on my vag com it says seat occupancy sensor signal too high
Does anybody know which wires go to this sensor there’s three pin connectors under the seat I have cleaned and sprayed everything black one red one and green black is empty
Please help if anyone has any information
I’m planning to put resistors on to bypass sensor
If this works I can replace iTools whole seat
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.