Audi Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
567 Posts
Discussion Starter #1
Well today I installed an audi retrofit bluetooth kit from Kufatec. About 3 hours work considering I'd never taken audi A6 C6 apart before.

Stripped the interior on the passenger side, removed the seat, glovebox, lower trim and placed the module under the seat. Cut away a lot of the foam sound proofing to allow the kit to sit properly (audi must fit different carpets if you dont buy a phone).

Connected power at the fuse box and the MOST connections, ran the mic to the roof space and recoded using VAG. Boom, all burst into life. Paired with a V3 I think and off we jolly well went.

Then it was just a case of replacing all the trim.

Craig
 

·
Registered
Joined
·
5 Posts
Craig,

Have just ordered Bluetooth only kit from Kufatec - would you be prepared to install into A8 (4e)? Has 14 way adjustable powered seats - would this mean taking them out - could see this as being a bit of a mare!

Were the installation instructions in German for the BT kit you've just installed?

Quattrophenia
 
1 - 2 of 2 Posts
Top