Audi Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi, I recently purchased the Audi A6 2000 2.8 and after 1 month driving it noticed that when i brake the car shakes. When you pull away it's great. Maybe the engine or the ABS senosor? Under 40,000 miles. Any help would be greatly appreciated.
 

·
Registered
Joined
·
1 Posts
Hi.
I have a 1999 Audi A6 and I have had to replace my front rotors and pads
twice in 2 years...I have just taken the car back to the dealer because the
car 'pulsates' as I apply the brakes...is this a problem we are going to have
to live with?
 

·
Registered
Joined
·
2 Posts
It is very common for the rotors of eurpoean cars to be very sensitive to the torque applied to the wheel bolts. VW/Audi specs call for slightly less than 100 ft/lbs. Much more and the rotors will tend to warp due to the stress of the overtorquing or equally common uneven torque from bolt to bolt. I have often seen torque levels exceeding 200 to 250 ft/lbs after a brake job, a tire repair or rotation. I always retorque the wheel bolts after such service using a micro adjustable torque wrench.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top