Audi Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
After much diliberation i gave in and brought a tv tuner for the RNSE sat nav unit in my A4.

I thought it would be a case of just plugging in, but the cable has some loose wires which are part of the main cable but need to be connected to somware else.

Any help or advice would be welcome. Its my first non rover car so i have no idea about where to start!!
 

·
Registered
Joined
·
567 Posts
The loose wires are power (RED) Ground (brown). Canbus Hi & Lo (Black/Yellow & Black/White normally) and maybe if you have a fith wire K-line (grey).

These connect to the RNS-E wiring loom.

Then you need to VAG your RNS-E to add the TV option.

Then you need to upgrade all 4 antenna amplifiers to TV/Radio combined.

Then you need to replace the diversity switcher to be TV/Radio combined.

Then you need to run the cables from the diversity swicther to the TV module.

That's what you need to do to install TV.

Craig
 
1 - 2 of 2 Posts
Top