Audi Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
151 Posts
Discussion Starter #1
hi,programmed clocks to my a4 tdi 2001>b6 using vag-com
i dont know the exact softcoding,fuel gauge is reading 3 quarter full instead of full. also my old clock,when ignition was switched on all the clock needles use to light up red,now they dont,they only light up when my lights are switched on, any ideas on how to get rite softcoding,i can change things by altering the softcode but could do with some help!

clocks were coded last week,in that time i may have altered the original software coding by accident via vag-com,how do i get the original coding?

If i get the software coding i think my needles and gauge will work as they should!
 

·
Registered
Joined
·
224 Posts
Shouldn't this be in the B5 forum??
 

·
Registered
Joined
·
224 Posts
vw754 said:
as stated above my cars a b6!
My apologies, I merely thought that 2001 A4s were on the B5 chassis.

Unfortunately, I don't have an answer to your original request, though I am aware that you can experiment with the digits in the coding and see how you get on. As always, anytime you alter any of the codings, ALWAYS write down the original figures so you can go back if necessary.

Rgds
 
1 - 4 of 4 Posts
Top