Audi Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi Guys, I've just bought a 1996 80 1.6 and started doing some work on it last night. I replaced the cambelt and after that the car would not start.

I checked the timing and the belt is all timed up properly. I found that when I removed a plug to check for a spark that the plugs would only spark once.

Could someone tell me if the ignition system gets a pickup from a camshaft or crankshaft sensor and if so where they are located as I couldn't see anything. I'm thinking that I may have knocked something while I was worknig on the belt!

Any other suggestions as to what is wrong would be more than welcome!

Thanks
 
1 - 1 of 1 Posts
Top