Vibration

B5AUDIS4 · 02-28-2006, 01:58 AM

Hey guys. I ran into a problem. I've got a bit of a vibration coming from the front pasenger side of my S4 under moderate to hard acceleration. Only slightly noticable under low loads. I'm not sure exactly of what it could be though. I had the oil changed at Oil Cans(Yeah, I know...didn't do it myself. I was pressed for time). I also replaced the axle shaft on that side, and put on a new set of Tein Super Street coilovers. I know that I need to get it aligned, but the vibration doesn't feel like it's from the alignment. Nor a wheel being out of balance. Could it be that the shaft I got was bad and needs to be re-replaced?

**AllWheelGrip** · 02-28-2006, 04:09 PM

did u check ur control arms or ur sway bars

B5AUDIS4 · 02-28-2006, 08:36 PM

Actually, I'm just going to go ahead and replace the axleshaft again, along with all the control arms and two tie rod ends. As far as the sway bars go, they're brand new Hsports.

02-28-2006, 04:09 PM	#2 (permalink)
AllWheelGrip Super Moderator Join Date: Jun 2005 Posts: 1,725 Gallery: (0)	did u check ur control arms or ur sway bars __________________ There are many paths to the top of the mountain but the view will always be the same

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-28-2006, 01:58 AM	#1 (permalink)
B5AUDIS4 Senior Join Date: Mar 2005 Location: Beaverton, Or Posts: 170 Gallery: (0)	Hey guys. I ran into a problem. I've got a bit of a vibration coming from the front pasenger side of my S4 under moderate to hard acceleration. Only slightly noticable under low loads. I'm not sure exactly of what it could be though. I had the oil changed at Oil Cans(Yeah, I know...didn't do it myself. I was pressed for time). I also replaced the axle shaft on that side, and put on a new set of Tein Super Street coilovers. I know that I need to get it aligned, but the vibration doesn't feel like it's from the alignment. Nor a wheel being out of balance. Could it be that the shaft I got was bad and needs to be re-replaced?

Remove Advertisements Sponsored Links
Audi Forum Advertisement

02-28-2006, 08:36 PM	#3 (permalink)
B5AUDIS4 Senior Join Date: Mar 2005 Location: Beaverton, Or Posts: 170 Gallery: (0)	Actually, I'm just going to go ahead and replace the axleshaft again, along with all the control arms and two tie rod ends. As far as the sway bars go, they're brand new Hsports.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)