rear ABS sensor on 2.8Q

RobMorgan · 04-04-2007, 02:17 PM

just in the middle of replacing a rear bearing, but i cant disconnect the abs sensor from the hub
where does the other end of the cable finish? as i'll leave the sensor on

RobMorgan · 04-05-2007, 08:41 AM

i'm really struggling now
need some advice asap
cant get the sensor out of the hub, so i think i'm going to have to disconnect it at the other end
a freind of mine said that i should cut the wires, and then join it back together agin after i have replaced the bearing

RobMorgan · 04-05-2007, 01:40 PM

sorted now

couldnt get the sensor out the hub, but i found out that it goes under the rear seat, and it plugs in the loom
really easy when you know

04-04-2007, 02:17 PM	#1 (permalink)
RobMorgan Full Member Join Date: Dec 2006 Location: wrexham Posts: 133 Gallery: (1)	rear ABS sensor on 2.8Q just in the middle of replacing a rear bearing, but i cant disconnect the abs sensor from the hub where does the other end of the cable finish? as i'll leave the sensor on

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Audi Forum Advertisement

04-05-2007, 08:41 AM	#2 (permalink)
RobMorgan Full Member Join Date: Dec 2006 Location: wrexham Posts: 133 Gallery: (1)	i'm really struggling now need some advice asap cant get the sensor out of the hub, so i think i'm going to have to disconnect it at the other end a freind of mine said that i should cut the wires, and then join it back together agin after i have replaced the bearing

04-05-2007, 01:40 PM	#3 (permalink)
RobMorgan Full Member Join Date: Dec 2006 Location: wrexham Posts: 133 Gallery: (1)	sorted now couldnt get the sensor out the hub, but i found out that it goes under the rear seat, and it plugs in the loom really easy when you know

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)