Q7 seat and middle console disassembly (Vizualogic A-1250 installation)

[jdeungoc]

Hello,

I've purchased the Vizualogic A-1250 for my Q7. I've mounted the headrest and have been waiting for the FSM I ordered to arrive so I can disassemble the seat and wire things through. But I'm getting a bit impatient. I was thinking about running the wires into the middle console and hiding the control unit in there.

I've found absolutely no information about a Q7 specific installation. The install manual is all obvious wiring stuff, like "put the yellow plug into the yellow receptacle", duh. I've only seen a small document for the "Audi Rear Entertainment" system installation, but it references sections in other parts of the FSM (for example, "refer to section x.y.z to remove the seat panel").

Question is, does anyone have diagrams of where the various clips and screws are located for the two front seats and the middle console (the unit located behind the shifter where the cup holders live). I want to be sure that a clip is where I think it is before I start pulling on some plastic.

Thanks!

Joe